Hoophouse revisited

An old photo from the first time we pulled plastic in 2002.
Photo credit McCune Porter

Today we revisited the hoophouse and loosened up the outer layer of plastic. We’d accidentally pulled it too tight in our eagerness to get the task finished, and it couldn’t really inflate properly. (The air between the two layers provides insulation as well as structural strength – it stops the plastic flapping about and wearing out by rubbing on the bows). We only had a few inches spare because we had already trimmed the extra plastic off (did I say we were keen to get the job finished?) Hopefully, when it finishes re-inflating the result will be better than it was.

I’ve been busy proof-reading my book Sustainable Market Farming and I’m tired of sitting at the computer, so this post will be short on words and long on photos!

Fresh air hoophouse waiting for its plastic.
Photo credit Robbie Sproule

 

 

 

We tied the edge of the plastic round old tennis balls, so we could pull without tearing the plastic

We were lucky with the weather. You can see from Robbie’s picture that we had cowpeas, peppers and ginger growing at the time, and didn’t want a frost.

Here we are after throwing the ropes over the top, getting ready to pull the plastic over.
Photo credit Bridget Aleshire

 

Here’s the plastic rolled out along the length of the hoophouse, all tied to ropes. We’re on the far side, ready to pull.
Photo credit Bridget Aleshire

 

Starting to pull from the far side.
Photo credit Bridget Aleshire
Another view of the crew starting the pull.
Photo credit Bridget Aleshire

In case it’s not obvious, this amount of plastic is heavy! Our hoophouse is 96′ by 30′. The plastic was 100′ by 50′.

The plastic starts to move up.
Photo credit Bridget Aleshire
Progress!
Photo credit Bridget Aleshire

 

Halfway!
Photo credit Bridget Aleshire

The first layer was exciting, the second frustrating. The inner plastic is made to keep Infra-red radiation inside the hoophouse and also to disperse condensation, so water-bombs don’t drop down on the workers (or plants). It seems to have a slightly sticky, textured surface, which makes the second layer harder to pull over it. Our real downfall, though, was that the grass was dewy and we thoughtlessly pulled the outer layer over the wet grass before it went over the hoophouse. This made the two layers stick together.

Here’s a great picture of the tennis-ball-in-sock being thrown over the top to pull the second layer.
Photo credit Bridget Aleshire.

So, now we have the plastic on, we have been busy inside the hoophouse, sowing turnips, transplanting lettuce and chard. And harvesting radishes, tatsoi and peppers. We’ve pulled up the cowpeas, which are a seed crop, and sown turnips in their place. We’ve started pulling up the pepper plants and soon we’ll harvest the ginger. Next week!